With its 2026 update, the Maruti Brezza gained a 1.0-litre direct-injection turbo-petrol engine alongside the 1.5-litre naturally aspirated unit. The Mahindra XUV 3XO, on the other hand, comes with two 1.2-litre turbo-petrol engine options, though it’s the one with multi-point fuel injection (MPFI) that we’ll be looking at here. While a 6-speed manual is offered with both these sub-4-metre SUVs, the Mahindra’s MPFI engine can also be paired with a 6-speed automatic.
Explore full specs, features and a price breakdown in our Brezza Turbo vs XUV 3XO comparison.
Maruti Brezza vs Mahindra XUV 3XO turbo-petrol MT: Specifications
XUV 3XO’s MPFI engine is bigger and torquier, but the Brezza Turbo weighs less
Both SUVs are powered by three-cylinder turbo-petrol engines, but the XUV 3XO’s MPFI unit is larger by 199cc. Power outputs are nearly identical, with the Mahindra making just 1hp more. Where it pulls ahead is torque, with its 200Nm peak figure being 30Nm higher than the Brezza’s. The 3XO’s engine also delivers this peak torque 500rpm earlier in the rev range. However, the Brezza Turbo is 167kg lighter, which gives it the better power-to-weight ratio. The XUV 3XO MPFI’s higher torque still gives it a slight edge in terms of torque-to-weight.
Maruti Brezza vs Mahindra XUV 3XO turbo-petrol MT: 0-100kph acceleration test
XUV 3XO MPFI stays ahead of the Brezza Turbo all the way from a standstill
In our real-world acceleration tests, the XUV 3XO MPFI went from nought to 100kph in 11.58 seconds, which is 0.78 seconds quicker than the Brezza Turbo. It’s worth noting that the road surface was slightly wet when we tested the Maruti. The Mahindra gets off the line faster, and while the Brezza closes in by 60kph, the gap opens up again afterwards. By the time both cars hit 120kph, the XUV 3XO is 2.29 seconds ahead. The Brezza Turbo tops out at 116kph in third gear, so it needs an upshift to get to 120kph. Meanwhile, the XUV 3XO MPFI’s third gear is good for up to 132kph.

The Brezza’s direct-injection turbo engine builds speed in a smooth and linear manner, with hardly any lag at low revs. Refinement is a strong point too, with its three-cylinder thrum only coming through when pushed hard. While this engine doesn’t have much of a turbo kick, the XUV 3XO’s MPFI unit feels more energetic. It does have some turbo lag below 2,000rpm, but it picks up pace quickly once the turbo kicks in. It’s really refined, too. As for the gearboxes, the Brezza’s 6-speed manual is progressive and features a light clutch, while the XUV 3XO’s has long throws.
What community is saying on the Brezza?
Maruti Brezza vs Mahindra XUV 3XO turbo-petrol MT: In-gear acceleration tests
Brezza Turbo out-accelerates the XUV 3XO MPFI in third and fourth gears
Despite offering less torque, the Brezza Turbo is the quicker of the two when accelerating in third and fourth gears. It goes from 20kph to 80kph in third gear 0.70 seconds sooner than the XUV 3XO MPFI. The gap grows to 0.88 seconds in favour of the Maruti between 40kph and 100kph in fourth gear.
Maruti Brezza vs Mahindra XUV 3XO turbo-petrol MT: Prices
Brezza Turbo starts at a lower price, but the top-end XUV 3XO MPFI is more affordable
The entry-level Mahindra XUV 3XO with the MPFI turbo-petrol engine costs Rs 29,000 more than the equivalent Maruti Brezza Turbo. At the top end, however, it’s the Brezza Turbo that’s dearer by Rs 1.26 lakh. The XUV 3XO MPFI is the quicker SUV from a standstill, while the Brezza Turbo is the stronger performer when accelerating in gear.
Autocar India’s testing standards
Before we conduct our performance tests, we check and maintain tyre pressures based on the manufacturer’s recommendation and ensure the car has a full tank of fuel. The car is then tested in a controlled environment with two people on board, and the data is collected via highly accurate GPS-based timing equipment.
Prices are ex-showroom, India.

































