autocar-logo
Delhi

Ducati Multistrada 1200 Enduro analysed

We take a closer look into the mechanical differences of both, the 1200 Enduro and its sibling the 1200 S.
2 min read2 Sep '16
Autocar India News Desk

Ducati’s Multistrada, is known for being a sporty and sophisticated adventure tourer. But, considering the competition, its adventure credentials were a little lacking. Well, Ducati has gone and fixed that with the Multistrada 1200 Enduro and it is now on sale in India for Rs 17.44 lakh (ex-showroom, Delhi). Read on to find out just how deep the differences are between the Enduro and its road-going sibling the 1200S.

Engine

At the heart of the Enduro sits the strong 1,198cc L-Twin engine and 136Nm of torque. Both numbers are generated at the same rpms as the road-biased Multistradas. This variable valve-timing equipped engine widened usability on-road and will be even more important off-road.

Gearbox and ratios

There is change here. While the primary ratio (from crank to gearbox) is the same, the final drive (the chain’s drive’s front sprocket to wheel sprocket ratio) on the Enduro is shorter (which means less top speed, but more grunt to help you scramble along dusty and slushy trails. But to really help the Enduro crawl, the first gear has been shortened too.

Chassis

The road-going Multistrada has a sporty trellis frame setup, so while the Enduro is also built around that design, it has been tweaked to build its off-road credentials. The changes start from the geometry as the Enduro uses a more relaxed rake angle (25deg vs 24deg) and more trail (110mm vs 106mm). Along with a longer wheelbase (1,594mm vs 1,529mm), the Enduro should offer a greater sense of stability. The change in wheelbase is also because of a new longer dual-sided swingarm, which is better suited to handle the abuse dished out in the wild. A beefed up bash plate should help when the suspension runs out of travel. The Enduro’s dry weight is 13kg higher and the difference in wet weight is a more considerable 19kg, no doubt down to the bigger 30-litre fuel tank.

Suspension, wheels and tyres

When it comes to crawling, the new rims and tyres will help. The Enduro uses wire spoke wheels; the front is a 19-inch wheel compared to the Multistrada’s 17-inch alloy. The rear continues to be a 17-inch on both versions, however the Enduro uses a 170/60 profile as compared to the 190/55 unit on the road-biased Multi. Both versions use Pirelli Scorpion Trail II tyres. However, for those interested in really mucking about, you could opt for the Pirelli Scorpion Rally tyres. Interestingly, the Enduro uses 320mm discs at the front instead of the 330mm units on the other Multistradas.

As can be expected of an adventure bike, the ground clearance is 205mm, up from the 1200 S’ 180mm. Suspension travel has also been increased to 200mm at both ends, up from 170mm. The Enduro also uses Ducati’s semi-active electronically adjustable Skyhook EVO system, that changes damping rates according to the road conditions. It helps while riding off-road too.
 

Battery-less hybrid

A hybrid system that does away with dependence on conventional batteries; promises on-board charging, no battery pack replacement and far lower costs
3 min read26 Aug '16
Sergius Barretto

Motor unit fixes to hub and capacitor pack location varies depending on model packaging in question.

In conversation with John Abraham, the petrolhead

The Bollywood actor talks about his growing collection of two- and four-wheelers and how he plans to bring together motorcycles and cinema.
2 min read12 Aug '16
Nishant Parekh

Suzuki Hayabusa: Make in India

We check into Suzuki Motorcycle India’s Gurgaon factory to watch the legendary Hayabusa come to life.
3 min read11 Aug '16
Autocar India News Desk

Unlike in Japan, the assembly line is completely manual.

Operators were hand picked from the existing lines. Skill, patience and careful handling of parts were critical.

One operator from India underwent a week-long training in Japan. The others were trained in India by a Japanese engineer.

There’s a list of names that’s put up outside this caged room. Only those on it, can enter.

Many levels of quality inspections are conducted through the assembly process.

Saree guard is surprisingly discreet, and unsurprisingly, very well designed.

“Could I help build one? Please?!!” But I didn’t ask. I knew what the answer would be.

Front number plate holder looks very solid, but it is an eyesore.

The tool kit is from Japan. However, the medical kit is for India only and is borrowed from the Gixxer.

Unlike in Brazil, the engine for India comes assembled. Rest of the motorcycle comes in pieces.

Soft cloth protects exhaust pipe while attaching end can.

Tools and equipment have been imported from Japan.

The men in white make the Hayabusa in India. The men in blue, Yoshiaki Harada (left) and Suresh Babu (right), helped get this project off the ground.

Ideal speed for 100cc motorcycle

What’s the fastest speed I should be doing on my 100cc bike so as to not affect engine life?
1 min read5 Aug '16
Staff Writer

Polaris off-road track experience

Get ready to experience the might of Polaris’ go-anywhere ATVs just outside the city limits.
2 min read29 Jul '16
Sherman Hale Nazareth
Ducati Multistrada 1200 Enduro analysed - Introduction | Autocar India